S1 rallye inlet manifold

[Yeti]

this a good mod for a vtr engine? apparently its 8mm bigger than vtr one?

i have a 51plate 106 independance with an 03 vtr engine sittin at 117bhp...lookin to get it up thanks in advance

[leeds106]

S1 inlet wont fit your engine as the inlet port spacings are different im afraid

[Yeti]

thats a pity been told it will fit an 8v tu engine aswell

[Jack The Lad]

i thought it would fit, but i could be wrong

they are a lot better inlet manifold, and the plenum is a lot bigger

my mate had this done but he had the s1 rallye head aswell, you may need to do that.

but saying that if the 1.6 block will go onto the 1.3 head then th port spacing probably wont have changed so it should go staight to the vtr head

[Barra87]

the rallye inlet will only fit pre 2001 engines, on the 8v's with a three plug ecu (2001 onwards) the inlet port spacing is different. You could use the rallye head as it will fit the 03 vtr bottom end but its alot of work for probably not much of a gain and it will need a remap to run right.

[106_Andy]

hey would a S1 rallye inlet fit a 1.0l? would i need the rallye ECU too?
just an idea ;)

[j106]

Would it fit a 1.1?

[106_Andy]

more likely to fit a 1.1 than a 1.0 imo... i dunno

[Yeti]

thanks for that...mechanic said it will fit hes pug daft but would be alot of pissin about with sensors...i just got a bmc(or somethin like it) enclosed induction so see how that goes...plenty other mods i can do at the moment lol